• pro audio Line Array System
  • pro audio pro speaker
  •  Professional Active Speaker
  • pro audio pa speaker
  • pro audio Amplifier
  • Guitar Amplifier
  • pro audio Loudspeaker
  • pro Peripheral Equipment
  • pro audio accessories

HomePage >Paaudio Products

Power Amplifier PV4080

Information:

    PV4080 Power amplifier, led display amplifier

Description:

    
SPECIFICATIONS PV4080 Moto Tansistor PV4080Hz Moto Tansistor
  STEREO   MODE   (Both   Channels   Driven)
8   ohms    
  FTC 20Hz -20   kHz,   0.1% THD 1100   W 1300   W
4   ohms    
  FTC20   Hz -20   kHz,   0.1% THD 1650   W 1950   W
2   ohms    
   EIA   1   kHz,   1%   THD 2600W 3200   W
  BRIDGE   MONO   MODE
8   ohms    
  FTC   20Hz-20kHz,   0.1%THD 3200W 3800   W
4   ohms    
 EIA   1 kHz,   1% THD 4800   W 6000W
Signal   to   Noise,   20   Hz-20kHz 106   dB 108   dB
Distortion   (SMPTE-IM) Less   than   0.01% Less   than   0.02%
Input   Sensitivity   @   8   ohms 1.15V   (+3.4   dBu) 1.16V   (+3.5   dBu)
Voltage   Gain 52x   (37   dB) 54x   (40   dB)
Power   Requirements 20A 20A
1/8   power   pink   noise   at   4   ohms  
  ALL   MODELS
Distortion   (Typical)  
 20Hz -20kHz:10dB below rated   power Less   than   0.03%   THD,   4   and   8   ohms
1.0 kHz   and   below:   full   rated   power Less   than   0.03%   THD,   4   and   8   ohms
Frequency   Response 20   Hz-20   kHz,   ±1   dB
-3   dB   points:   5   Hz   -   50   kHz
Damping   Factor,   1   kHz and below Greater   than   300   at   8   ohms
Input   Impedance 10k   ohms   unbalanced,   20k   ohms   balanced
Input   Clipping 10   Vrms   (+22   dB)
Cooling Continuously   variable-speed   fan,   rear-to-front   air   flow
Connectors,   each   channel Input:   Active   balanced;   barrier   strip,   XLR   and   1/4"   (6.3mm)
TRS   tip   and   XLR   (pin   2   positive)
Output:   touch-proof   binding   posts   and   Neutrik®   Speakon®
Controls Front:   AC   switch,   Ch.   1   and   Ch.   2   gain   knobs
Rear:   10-position   DIP   switch
Indicators Power-On:   Green   LED
Signal:   Yellow   LED   (1   per   channel)
Clip:   Red   LED   (1   per   channel)
Amplifier   Protection Stable   into   reactive   or   mismatched   loads
Load   Protection On/off   muting,   AC   coupling   ,   triac   crowbar   ,   on   each   channel)
Power   Requirements 100,   120,   230   VAC,   50-60   Hz
Dimensions 480*480*100(mm)

[Click to back]