• pro audio Line Array System
  • pro audio pro speaker
  •  Professional Active Speaker
  • pro audio pa speaker
  • pro audio Amplifier
  • Guitar Amplifier
  • pro audio Loudspeaker
  • pro Peripheral Equipment
  • pro audio accessories

HomePage >Paaudio Products

Power Amplifier (PK Series)

Information:

    PK PROFESSIONAL AUDIO SYSTEM, PK Series power amplifier provide extensive protection features such as Overheat short currents, DC protection, zero current, clip limiter, soft start

Description:

    

SPECIFICATIONS PK500 PK1000 PK2000 PK3000 PK4000
  STEREO   MODE   (Both   Channels   Driven)
8   ohms          
Stereo Power 300   W 400   W 500   W 600   W 700   W
4   ohms          
Stereo Power 450   W 620   W 750   W 1050   W 1300   W
2   ohms          
 EIA   1kHz,   1% THD 720W 950   W 1200   W 1650   W 2000   W
  BRIDGE   MONO   MODE
8   ohms          
FTC 20Hz - 20kHz,   0.1% THD 870W 1150   W 1450   W 2050   W 2450   W
4   ohms          
   EIA 1kHz,   1%THD 1450   W 1850   W 2400   W 3300   W 4000   W
Signal   to   Noise,   20Hz-20kHz 98   dB 100   dB 101   dB 102   dB 104   dB
  ALL   MODELS
Distortion (Typical)  
 20Hz-20kHz:10dB   below rated   power Less   than   0.03%   THD,   4   and   8   ohms
1.0kHz and below: full   rated   power Less   than   0.03%   THD,   4   and   8   ohms
Frequency   Response 20   Hz-20   kHz,   \1   dB
-3   dB   points:   5   Hz   -   50   kHz
Damping Factor, 1kHz and below Greater   than   300   at   8   ohms
Input   Impedance 10k   ohms   unbalanced,   20k   ohms   balanced
Input   Clipping 10   Vrms   (+22   dB)
Cooling Continuously   variable-speed   fan,   rear-to-front   air   flow
Connectors,   each   channel Input:   Active   balanced;   barrier   strip,   XLR   and   1/4"   (6.3mm)
TRS   tip   and   XLR   (pin   2   positive)
Output:   touch-proof   binding   posts   and   Neutrik®   Speakon®
Controls Front:   AC   switch,   Ch.   1   and   Ch.   2   gain   knobs
Rear:   10-position   DIP   switch
Indicators Power-On:   Green   LED
Signal:   Yellow   LED   (1   per   channel)
Clip:   Red   LED   (1   per   channel)
Amplifier   Protection Stable   into   reactive   or   mismatched   loads
Load   Protection On/off   muting,   AC   coupling   ,   triac   crowbar   ,   on   each   channel)
Power   Requirements 100,   120,   230   VAC,   50-60   Hz
Dimensions 483*480*143(mm)
 

[Click to back]