首页 > 产品介绍
Power Amplifier (XTi Series)
基本介绍:
Power Amps XTi1000（XTi2000）（XTi4000）（XTi6000） XTi Series power amplifier provide extensive protection features such as Overheat short currents, DC protection, zero current, clip limiter, soft start
产品描述:
| SPECIFICATIONS | XTi1000 | XTi2000 | XTi4000 | XTi6000 |
| STEREO MODE (Both Channels Driven) | ||||
| 8 ohms | ||||
| FTC20Hz -20kHz,0.1%THD | 300W | 500 W | 800 W | 1000W |
| 4 ohms | ||||
| FTC20Hz -20kHz,0.1%THD | 500W | 700W | 1100W | 1600W |
| 2 ohms | ||||
| EIA 1kHz, 1%THD | 700 W | 1200W | 1500W | 1800W |
| BRIDGE MONO MODE | ||||
| 8 ohms | ||||
| FTC20 Hz -20 kHz, 0.1%THD | 1150W | 2050W | 2450W | 2900W |
| 4 ohms | ||||
| EIA 1kHz, 1%THD | 1850W | 2400W | 4000W | 4800W |
| Signal to Noise, 20 Hz-20kHz | 100dB | 102dB | 104dB | 106dB |
| ALL MODELS | ||||
| Distortion (Typical) | ||||
| 20 Hz -20kHz: 10dB below rated power | Less than 0.03% THD, 4 and 8 ohms | |||
| 1.0kHz and below: full rated power | Less than 0.03% THD, 4 and 8 ohms | |||
| Frequency Response | 20 Hz-20 kHz, ±1 dB | |||
| -3 dB points: 5 Hz - 50 kHz | ||||
| Damping Factor, 1kHz and below | Greater than 300 at 8 ohms | |||
| Input Impedance | 10k ohms unbalanced, 20k ohms balanced | |||
| Input Clipping | 10 Vrms (+22 dB) | |||
| Cooling | Continuously variable-speed fan, rear-to-front air flow | |||
| Connectors, each channel | Input: Active balanced; barrier strip, XLR and 1/4" (6.3mm) | |||
| TRS tip and XLR (pin 2 positive) | ||||
| Output: touch-proof binding posts and Neutrik® Speakon® | ||||
| Controls | Front: AC switch, Ch. 1 and Ch. 2 gain knobs | |||
| Rear: 10-position DIP switch | ||||
| Indicators | Power-On: Green LED | |||
| Signal: Yellow LED (1 per channel) | ||||
| Clip: Red LED (1 per channel) | ||||
| Amplifier Protection | Stable into reactive or mismatched loads | |||
| Load Protection | On/off muting, AC coupling , triac crowbar , on each channel) | |||
| Power Requirements | 100, 120, 230 VAC, 50-60 Hz | |||
| Dimensions | 480*480*100(mm) | |||