首页 > 产品介绍
Power Amplifier (PS Series)
基本介绍:
PS Pro Amplifier
产品描述:
SPECIFICATIONS | PS300 | PS400 | PS500 | PS600 | PS700 | PS800 | PS1300 |
STEREO MODE (Both Channels Driven) | |||||||
8 ohms | |||||||
Stereo Power | 300 W | 400 W | 500 W | 600 W | 700 W | 800 W | 1300 W |
4 ohms | |||||||
Stereo Power | 450 W | 620 W | 750 W | 1050 W | 1300 W | 1500 W | 2500 W |
2 ohms | |||||||
EIA 1kHz, 1% THD | 720W | 950 W | 1200 W | 1650 W | 2000 W | 3000 W | 3900W |
BRIDGE MONO MODE | |||||||
8 ohms | |||||||
FTC 20Hz - 20kHz, 0.1% THD | 870W | 1150 W | 1450 W | 2050 W | 2450 W | 3550 W | 4500W |
4 ohms | |||||||
EIA 1kHz, 1%THD | 1450 W | 1850 W | 2400 W | 3300 W | 4000 W | 4500 W | 4800W |
Signal to Noise, 20Hz-20kHz | 98 dB | 100 dB | 101 dB | 102 dB | 104 dB | 104 dB | 106 dB |
ALL MODELS | |||||||
Distortion (Typical) | |||||||
20Hz-20kHz:10dB below rated power | Less than 0.03% THD, 4 and 8 ohms | ||||||
1.0kHz and below: full rated power | Less than 0.03% THD, 4 and 8 ohms | ||||||
Frequency Response | 20 Hz-20 kHz, ±1 dB | ||||||
-3 dB points: 5 Hz - 50 kHz | |||||||
Damping Factor, 1kHz and below | Greater than 300 at 8 ohms | ||||||
Input Impedance | 10k ohms unbalanced, 20k ohms balanced | ||||||
Input Clipping | 10 Vrms (+22 dB) | ||||||
Cooling | Continuously variable-speed fan, rear-to-front air flow | ||||||
Connectors, each channel | Input: Active balanced; barrier strip, XLR and 1/4" (6.3mm) | ||||||
TRS tip and XLR (pin 2 positive) | |||||||
Output: touch-proof binding posts and Neutrik® Speakon® | |||||||
Controls | Front: AC switch, Ch. 1 and Ch. 2 gain knobs | ||||||
Rear: 10-position DIP switch | |||||||
Indicators | Power-On: Green LED | ||||||
Signal: Yellow LED (1 per channel) | |||||||
Clip: Red LED (1 per channel) | |||||||
Amplifier Protection | Stable into reactive or mismatched loads | ||||||
Load Protection | On/off muting, AC coupling , triac crowbar , on each channel) | ||||||
Power Requirements | 100, 120, 230 VAC, 50-60 Hz | ||||||
Dimensions | 483*480*143(mm) |